Uni-Kit has released a V7.0 Epson Resetter which is used to reset the chip on an Epson ink cartridge, and does not change the property of the cartridge itself. In order to reuse an Epson ink cartridge, it needs to be both “reset” and “refilled”.
Resettable Cartridge Models with the Version 7.0 Resetter:
Epson T1241-T1244 (low capacity)
Epson T1251-T1254???standard capacity???
Epson T1241-T1244 (low capacity)
Epson T1261-T1264???high capacity???
Epson T1251-T1254 (standard capacity)
Epson T1261-T1264 (high capacity???
Epson T1271-T1274???ultrahigh capacity
Resettable Printer models:
Epson Stylus NX125, NX127, NX130, NX230, NX330, NX420, NX420, NX430 and more…
Epson Workforce 60, 320, 320 , 323, 325, 435, 520, 545, 630, 633, 645, 840, 845 and more…
HOW TO USE THE UNI-KIT RESETTER
The pins on the resetter should tightly contact the terminals on the chip of the cartridge, be sure to press against the pins firmly. When the chip makes proper contact with the pins on the resetter, an LED light in the resetter will light up (starts out RED, and after 2-3 seconds will blink and then turn GREEN). GREEN means a successful reset.
If the LED stays red, it could mean that the chip on the cartridge is abnormal and not resettable. Once the cartridge has been reset, refill it and install it into the printer
IMPORTANT:
The chip on the cartridge has 7 pins (5 on the top row and 2 on the bottom row). The pin on the far left of the top row should not make contact with the resetter pins.
TROUBLESHOOTING:
1. The LED in the universal chip resetter does not flash/turn green. Answer: a). Make sure that the pins make good contact with the chip terminals b). If the design of the chip is different from OEM cartridges, the resetter may have problems trying to recognize it.
<!--[if !supportLineBreakNewLine]--><!--[endif]-->
2. Cartridges are reset successfully (GREEN light on resetter), but printer does not recognize them as full* Answer: The printer reads more than just the chip when determining the ink level status for the cartridge. The printer also reads ink level sensors INSIDE the cartridge, so the cartridge needs to be both properly resetted AND properly refilled in order for the printer to recognize it as full. During the refilling process, air could enter into the sensor areas. The cartridge will only work if it is properly refilled AND resetted.
Please note that this resetter is designed to reset OEM (original brand) chips. It is not possible to test it or develop it to work on all types of 3rd party compatible chips, while we know that it does work on 3rd party compatible chips that we have tested, we cannot guarantee that it will work on all compatible chips, but it is guaranteed to work on the original brand chips.
Please click here to download attachment link
Please click here to download attachment link