0 votes
21 views
in Inkjet by (400 points)

1 Answer

+1 vote
by (400 points)

Perform a Hard reset on the printer and make sure that the printer is connected directly to the wall outlet and not to the surge protector.

 

Remove all the ink cartridges and then try to perform a hard reset on the printer.

With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.

Remove USB cable, if present.

Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.

Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord and then plug back the power cord to the printer.

Turn on the printer and wait till warm-up period finishes and the printer is idle.

Now insert the ink cartridges and then try to print a test page and check if it works.

Categories

Welcome to Inklibrary Q&A, where you can ask questions and receive answers from other members of the community.
...